Surface Seal
SKU:
P001431
Also adheres to vertical surfaces. Operating temperature range from –60 °C to +150 °C. For sealing gap widths of 0.1 to 0.3 mm. Slow curing (ready for use after 2 – 4 h) and can be dismantled. Resistant to stresses and vibrations.
Learn More
- resistant to stresses and vibrations
- adheres well to vertical surfaces
- good chemical resistance to petrol, oil, water/glycol
- curing without oxygen (anaerobic)
- EUH208 Contains Diisopropylbenzene hydroperoxide. May produce an allergic reaction.
- EUH210 Safety data sheet available on request.
Also adheres to vertical surfaces. Operating temperature range from –60 °C to +150 °C. For sealing gap widths of 0.1 to 0.3 mm. Slow curing (ready for use after 2 – 4 h) and can be dismantled. Resistant to stresses and vibrations.
Sealing of gearbox flanges, bearing covers and engine, differential and housing covers.
Application
The components to be sealed must be free from contaminants such as oil films, dirt, paint or other coating materials. The optimum seal is achieved by roughening the surfaces.Other information
Due to the anaerobic properties, there must always be enough air in the bottle. Otherwise the adhesive could harden prematurely. The bottle should therefore only be filled up to about 1/3. However, the quantity always corresponds to the content indicated on the container.Product Information
Product Information
Safety data sheets
Safety data sheets
Images and documents
Product Information
Product Information
Safety data sheets
Safety data sheets
Images and documents
